Horizontal Axis Coiler

The horizontal axis coiler is suitable to collect in the best way every type of wires in coils on tubular carries with non stop processing.
The framework structure made of welded steel sheets which guarantees operation exempt from vibrations.
The coiling capstan is made by forged and induction hardened steel and the drawing surface additional coated with thungsten carbide .
The coiling capstan and die holder has water cooling system.
Winding speed up to 25 m/s in perfect synchronisation with connected wire drawing machine.
The braking system integrated by a pneumatic brake for emergency purposes, and allows a full automatic braking control without wire break in any situation
The horizontal axis coiler is designed to contain all the elements of the coiler, including the drive motor and electrical auxiliaries
wired to a common junction box.
Coiling Block(drawing capstan)
The motor is synchronized with the wire drawing machine, by means of the final dancer arm. On the
tending side is installed a protection door is to be opened for wire threading as well as for adjustingt the
straightening device and drawing die holder.
The coiling block runs loosely on ball bearings on the coiling shaft. The coiling block is made of high-grade
cast iron with reinforced wear-resistant surfaces in the wire folding area.The wire guide arm bolted to the
coiling block is supported by the carrier.

Lowering device
In order to achive a better laying on the carrier, the coiler is equipped with a combined pattern laying and
lowering device. A rotary ring with a guide finger puts down the wire windings onto the carrier in pattern
form.
The lowering device is limiting the falling height of the windings. If the carrier is empty the collecting fingers
are in the upper position, just in front of the carrier end. If the carrier is absolutely full, the collecting fingers
lower automatically and give the carrier slightly free for further collection.
Winding Arm
The winding capstan is asolid welded structure which is rigidly connected to the coiling shaft by means of
a feather key. The bearing is supported in a cast-iron flange which is screwed down to the machine
body.The wire deflection rolls, the die holder and a straightener are installed on the winding capstan in
order to obtain a faultless wire quality.

Carbon: Low, Medium, High
Block Dia.: 500 - 650 mm
Wire Dia.: 1.3 - 4.5 mm

Manual Dynamic Spooler

Dual Wire Drawing Machine

Rod Breakdown Line